Compaq AlphaPC 164LX Manual de usuario Pagina 35

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 82
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 34
Memory and Microprocessor Configuration 5–3
Increasing Microprocessor Speed
5.3 Increasing Microprocessor Speed
This section describes how to complete the following actions to increase
microprocessor speed:
Replace the Alpha 21164 microprocessor with an Alpha chip that has a higher
speed rating.
Reconfigure the clock divisor jumpers.
5.3.1 Preparatory Information
Caution: Static-Sensitive Component – Due to the sensitive nature of electronic
components to static electricity, anyone handling the microprocessor
must wear a properly grounded antistatic wriststrap. Use of antistatic
mats, ESD approved workstations, or exercising other good ESD prac-
tices is recommended.
An Alpha 21164 microprocessor with a higher speed rating is available from your
local distributor. See Appendix A for information about supporting products.
When replacing the microprocessor chip, also replace the thermal conducting
GRAFOIL pad. See Appendix A for information about the parts kit, which includes
the heat sink, GRAFOIL pad, two hex nuts, heat-sink clips, 60-mm fan, fan guard,
and four screws.
5.3.2 Required Tools
The following tools are required when replacing the microprocessor chip:
A TS30 manual nut/torque driver (or equivalent) with the following attachments is
required to affix the heat sink and fan to the microprocessors IPGA package:
1/4-inch hex bit
7/16-inch socket with 1/4-inch hex drive
#2 Phillips-head screwdriver bit
Vista de pagina 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 81 82

Comentarios a estos manuales

Sin comentarios