Full Installation on Compaq Tru64 UNIX
5.2 Installing RTR on Compaq Tru64 UNIX
5.2 Installing RTR on Compaq Tru64 UNIX
Before you start the installation, read Section 5.1, Preparing for RTR
Installation on Compaq Tru64 UNIX .
You can install RTR locally (using CD-ROM media) or from a server area. If
you encounter any failures during installation, see Appendix A.
5.2.1 Distribution Media
You can obtain Reliable Transaction Router software on CD-ROM or using
RIS.
5.2.1.1 Using CD-ROM Consolidated Distribution Media
This procedure loads RTR files on to a disk belonging to the system where you
perform the installation. When RTR is run, its executable images are mapped
into memory on your system.
Follow these steps to install RTR from CD-ROM media:
1. Mount the media on the appropriate disk drive.
2. Log in as superuser (login name
root
) to the system where you will install
RTR.
3. Make sure you are at the root (/) directory by entering the following
command:
# cd /
4. Use the
setld
utility to check if you have a version of RTR already
installed:
# setld -i | grep RTR
5. If RTR is already installed on your system, see Section 2.2.3 for information
on uninstalling RTR and removing related processes.
6. Specify the
/CD-ROM
directory to be the mount point for the distribution file
system on the drive. If your drive is
rz0
, enter the following command:
# mount -dr /dev/rz0c /CD-ROM
7. Enter a
setld
command that requests the load function (
-l
) and identifies
the directory in the mounted file system where RTR subsets are located.
For example, if the directory location for these subsets is
/CDROM/rtr400
,
enter the following command:
# setld -l /CDROM/rtr400/kit
Full Installation on Compaq Tru64 UNIX 5–7
Comentarios a estos manuales