Compaq AA-RHGWC-TE Manual de usuario Pagina 261
- Pagina / 362
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Figure 8–14: TL895 Tape Library Internal Cabling
Robotics
Controller
SCSI ID 0
SCSI Port 5
SCSI Port 4
SCSI Port 3
Tape Drive 0
SCSI ID 1
Tape Drive 1
SCSI ID 2
ZK-1397U-AI
SCSI Port 8
SCSI Port 7
SCSI Port 6
SCSI Port 2
SCSI Port 1
Terminator
Terminator
Terminator
Terminator
PN 0415619
SCSI Jumper Cable
PN 6210567
Tape Drive 2
SCSI ID 3
Tape Drive 3
SCSI ID 4
Tape Drive 4
SCSI ID 5
Tape Drive 5
SCSI ID 1
Tape Drive 6
SCSI ID 2
Jumper
Cable
Jumper
Cable
8.10.4 Upgrading a TL895
The TL985 DLT automated tape library can be upgraded from two or
five tape drives to seven drives with multiple DS-TL89X-UA upgrade
kits. Besides the associated documentation, the upgrade kit contains one
TZ89N-AV tape drive, a SCSI bus terminator, a SCSI bus jumper (part
number 6210567) so you can place more than one drive on the same SCSI
bus, and other associated hardware.
Before the drive is physically installed, set the SCSI ID rotary switches
(on the library printed circuit board) to the same SCSI ID that will
be electronically set. After the drive installation is complete, set the
Configuring a Shared SCSI Bus for Tape Drive Use 8–47
- TruCluster Server 1
- Contents 3
- UltraSCSI Hardware 4
- Hardware 4
- 6 Using Fibre Channel Storage 5
- Server Configuration 7
- Contents ix 9
- Examples 11
- Contents xiii 13
- Contents xv 15
- About This Manual 17
- Related Documents 18
- About This Manual xix 19
- About This Manual xxi 21
- Reader’s Comments 22
- Conventions 22
- About This Manual xxiii 23
- Introduction 25
- 1.2 Memory Requirements 26
- 1.3 Minimum Disk Requirements 26
- 1.4 Generic Two-Node Cluster 28
- Memory Channel 29
- Shared SCSI Bus 29
- Introduction 1–7 31
- 1–8 Introduction 32
- Increased Disk Configurations 33
- 1–10 Introduction 34
- Introduction 1–11 35
- 1–12 Introduction 36
- 1–14 Introduction 38
- Introduction 1–15 39
- 1–16 Introduction 40
- Introduction 1–17 41
- ZK-1748U-AI 44
- P00>>> 46
- 2.4 Disk Device Restrictions 51
- 2.6 SCSI Signal Converters 52
- 2.8 SCSI Cables 54
- 3.2 SCSI Bus Performance 59
- 3.2.2 Transmission Methods 60
- 3.2.3 Data Path 61
- 3.2.4 Bus Speed 61
- 3.4 SCSI Bus Length 62
- UltraSCSI Hubs 63
- CXO5744A 64
- 3.6 UltraSCSI Hubs 64
- Differential symbol 66
- ZK-1412U-AI 66
- ZK-1448U-AI 70
- ZK-1447U-AI 71
- Member System 2 81
- Member System 1 81
- Using UltraSCSI Hardware 83
- # umount /mnt 87
- Radial Configuration 89
- Commands 92
- KZPBA-CB SCSI ID 96
- ZK-1451U-AI 100
- Interconnect 101
- 5.1.1 MC1 and MC1.5 Jumpers 102
- 5.1.2 MC2 Jumpers 103
- Linecards 109
- ZK-1197U-AI 109
- ZK-1530U-AI 120
- ZK-1522U-AI 121
- ZK-1523U-AI 122
- ZK-1524U-AI 123
- ZK-1525U-AI 124
- MC1 in Second System 125
- Configuration 126
- Using Fibre Channel Storage 127
- 6.2 Fibre Channel Overview 130
- ZK-1534U-AI 133
- ZK-1536U-AI 134
- ZK-1531U-AI 136
- ZK-1706U-AI 138
- ZK-1707U-AI 139
- 6.4.1 Zoning 140
- ZK-1709U-AI 141
- Select Menu: 145
- Configuration Menu 145
- Adapter Module 149
- Reformatting nvram 152
- Installation 154
- 6.6.1 Before You Install 162
- Cluster Member 179
- POO>>> init 181
- Failover Mode 183
- 6.7.1 Overview 184
- as follows: 185
- Adapter Information 188
- Present, Logged in, F_PORT 190
- ZK-1749U-AI 195
- ZK-1750U-AI 198
- ZK-1751U-AI 199
- 2 The type of CSB node: 209
- P00>>> Esc Esc scm 213
- SCM_E0> reset 213
- SCM_E0> set hp_count 2 213
- SCM_E0> power on 213
- Drive Use 215
- TZ88N−VA 216
- 8.1.2 Cabling the TZ88N-VA 217
- ZK-1761U-AI 218
- TZ88N-VA 218
- TZ89N-VW 218
- 8.1.4 Cabling the TZ88N-TA 219
- DS−TZ89N−VW 221
- 20/40 GB DLT Tape Drive 225
- 8.4 Compaq 40/80-GB DLT Drive 228
- ZK-1461U-AI 235
- Shared SCSI Usage 237
- Interface 242
- Figure 8–11 246
- DLT0 Idle 248
- DLT1 Idle 248
- Loader Idle 248
- 0>__________<9 248
- DLT2 Idle 249
- DLT3 Idle 249
- 26>__________<35 249
- Shared SCSI Bus Usage 250
- ZK-1324U-AI 254
- ZK-1625U-AI 256
- 8.10.4 Upgrading a TL895 261
- 8.11.2 MUC Switch Functions 264
- 8.11.4 Tape Drive SCSI IDs 265
- ZK-1326U-AI 267
- ZK-1327U-AI 268
- Figure 8–17 270
- Shown in Figure 8–16 270
- Shared Bus Usage 271
- Figure 8–18 280
- Shown in Figure 8–17 280
- Expansion Modules 283
- 8.13.1 General Overview 287
- Bus Usage 288
- SCSI Bulkhead 290
- ZK-1705U-AI 290
- Configurations Using External 293
- Non-UltraSCSI Devices 9–3 295
- ZK-1576U-AI 296
- Non-UltraSCSI Devices 9–5 297
- Non-UltraSCSI Devices 9–7 299
- FRONT VIEW 300
- REAR VIEW 300
- 9.3.1 BA350 Storage Shelf 301
- ZK-1338U-AI 302
- Non-UltraSCSI Devices 9–11 303
- ZK-1339U-AI 304
- Non-UltraSCSI Devices 9–13 305
- External Termination 306
- Non-UltraSCSI Devices 9–15 307
- Non-UltraSCSI Devices 9–17 309
- Figure 9–9 and Figure 9–10 311
- BA356s for storage 313
- Figure 9–10 313
- Figure 9–11 315
- Terminated Shared SCSI Bus 316
- Non-UltraSCSI Devices 9–25 317
- Non-UltraSCSI Devices 9–29 321
- ZK-1766U-AI 322
- Non-UltraSCSI Devices 9–31 323
- Non-UltraSCSI Devices 325
- Termination 326
- Termination (cont.) 332
- Console Commands 333
- KZPSA-BB and KZPBA-CB SCSI ID 337
- P00>>> boot dka600 342
- UBPG PUBLICATIONS MANAGER 362
- ZKO3-3/Y32 362
- 110 SPIT BROOK RD 362
- COMPAQ COMPUTER CORPORATION 362
- NASHUA NH 03062-2698 362
Relacionado con productos y manuales para Procesadores Compaq AA-RHGWC-TE
(422 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales