Compaq 157770-001 - DAT Drive 20/40 Tape Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 29
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
QuickSpecs
Compaq AlphaServer DS20E
Compaq AlphaStation DS20E
DA-10445 World Wide — Version 25 — June 4, 2002 15
Options
Step 10
Storage Adapters/Controllers (continued)
Maximum # Supported
Tru64 UNIX OpenVMS
PCI 3-channel Ultra2 LVD RAID controller, 64-bit, 64-MB cache
NOTES:
Supported with BA610-6D, BA356 DS-SL13R-xx or DS-SSL14-Rx shelves only.
BA610-6D Nile Card must be at rev 0B to support internal RAID.
When installed in BA356 shelves, part number DS-BA35X-FC is required for non-
factory installations. Graphics card is required to run the DS-KZPCC-CE console
utilities (SMOR) with SRM console versions lower than V6.0 or, alternatively can be
run via serial line and terminal emulation software for SRM V6.0 or higher.
PB2GA-JC/JD graphics cards are not supported.
EV6 systems not supported.
Tru64 UNIX V4.0F requires NHD3 and Patch Kit 4 (BL15) or later Tru64 UNIX V5.1
requires Patch Kit 3 (BL17) and Early Release Patch C462.
- Patch Kit 3 (BL17) is located at: T64V5117-C0046202-11060-Manual-ER-
20010615.tar
- Patch C462.02 is located at: http://ftp1.support.compaq.com/public/unix/v5.1/
NOTE: This website is available in English only.
TruCluster V5.1 (restricted to non-shared buses only)
2 with SRM V6.0
3 with SRM V6.1
V4.0F/4.0G/5.1/5.1A
- DS-KZPCC-CE
PCI 1-channel Ultra2 LVD backplane RAID controller, 64-bit, 16-MB cache
NOTES:
Supported with BA610-6D, BA356 and DS-SL13R-xx shelves only.
When installed in BA356 shelves, part number DS-BA35X-FC is required for non-
factory installations.
Graphics card is required to run the DS-KZPCC-AC console utilities (SMOR) with
SRM console versions lower than V6.0 or, alternatively can be run via serial line
and terminal emulation software for SRM V6.0 or higher. PB2GA-JC/JD graphics
cards are not supported.
EV6 systems not supported.
Tru64 UNIX V4.0F requires NHD3 and Patch Kit 4 (BL15) or later
Tru64 UNIX V5.1 requires Patch Kit 3 (BL17) and Early Release Patch C462.
- Patch Kit 3 (BL17) is located at: T64V5117-C0046202-11060-Manual-ER-
20010615.tar
- Patch C462.02 is located at: http://ftp1.support.compaq.com/public/unix/v5.1/
NOTE: This website is available in English only.
TruCluster V5.1 (restricted to non-shared buses only)
2 with SRM V6.0
3 with SRM V6.1
V4.0F/4.0G/5.1/5.1A
- DS-KZPCC-AC
PCI 1-port UltraSCSI RAID controller with 4-MB cache memory, includes RAID Array
230/Plus Subsystem software and documentation kit and VHDCI female connector; tape
drives not supported – 18.2GB or higher disk drives not supported on KZPAC-xx RAID
controllers
4 4
KZPAC-AA
PCI 3-port UltraSCSI RAID controller with 4-MB cache memory (uses one PCI slot),
includes RAID Array 230/Plus subsystem software and documentation kit; tape drives not
supported; 18.2-GB disk drives not supported; SCSI cable required for each active port;
requires BN37X-xx cable (.3 to 20 m) to connect to single-ended UltraSCSI shelf, and
BN31K-0E for external third port connection
2 2
KZPAC-CA
Same as KZPAC-CA with 8-MB cache memory 2 2
KZPAC-CB
Cache battery backup for KZPAC controller
KZPSC-UB
VHDCI male-to-VHDCI male UltraSCSI cable:
xx = 02, 2E [2.5], 03, 05, 10, 20, 25 m
NOTE: Manufacturing may substitute BN37A-02 cable for specific cabinet configurations.
BN37A-xx
SCSI cable/bulkhead assembly kit, supports one third-port connection from
KZPAC-CA/CB, allows external connection of one third port
BN31K-0E
SCSI cable/bulkhead assembly kit, supports two third-port connections from
KZPAC-CA/CB, allows external connection of two third ports
KZPAC-SB
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 28 29

Comentarios a estos manuales

Sin comentarios