Compaq Tru64 UNIX Guía de instalación descargar pdf (Pagina 113)

initializing partitions. For example:

P00>>> set console BOTH

7.2.3 Section E.4.3.3 (Conﬁguring Logical Partitions)

The instructions for setting the IO port mask ( lp_io_mask) do not take in

to account a partition with two IOP module. For this case, the lp_io_mask

is formed by combining (logical or) the masks for individual IOP modules

slots. For example, to assign IOP modules in slots 7 and 8 to partition 1,

lp_io_mask1 would be 180.

When assigning IOP modules to secondary partitions, it is important to

remember that one of the IOPs assigned to the partition must be connected to

a DWLPB with a KFE72 option installed. The KFE72 provides the console

serial port for secondary partitions.

7.2.4 Section E.4.3.7 (Disabling Automatic Boot Reset)

The Tru64 UNIX Installation Guide recommends setting the boot_reset

console environment variable to ON. This setting is not compatible with

Logical Partitions. The boot_reset console EV must be set to OFF.

7.2.5 Section E.4.3.8 (Set Memory Interleave Mode)

While setting the interleave mode to none, the console may echo a series of

Y characters to the console display screen (there could be several lines of Y

characters). This is not an error and can be ignored.

7.2.6 Section E.4.4 (Initializing Partitions)

The normal sequence of commands is as follows:

P00>>> set lp_count n

(where n is the number of partitions)

P00>>> init

(initialize the primary partition)

P00>>> lpinit

(start secondary partitions)

P00>>> boot

Documentation Notes 7–3

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 179 180

Sin comentarios

Compaq Tru64 UNIX Guía de instalación Pagina 113