Compaq HSZ80 Guía de instalación descargar pdf (Pagina 21)

Service Guide

EK-HSG80-UP. B01 Page 21

14.0 Completing the Upgrade

Use the following steps to complete the upgrade:

1. Reconfigure the kernel or reboot the server if necessary to configure all of the new units.

Using either the SWCC CLI or the maintenance terminal, check that the HSG80 controller

connection(s) to the host are set correctly. Use the command:

HSG80> SHOW CONNECTIONS

For connections whose status is listed as:

OL THIS or OL OTHER

Check that the operating system is set correctly for your server. The default setting is WINNT for

Windows NT. To change the operating system type for the online (OL) connections, use the

appropriate command for your system:

NOTE

Replace XX shown in the commands with the online

connection name when the “SHOW CONNECTIONS”

command was previously used in this step (above).

HSG80> SET !NEWCONNXX OPERATING_SYSTEM=SUN

HSG80> SET !NEWCONNXX OPERATING_SYSTEM=SGI

HSG80> SET !NEWCONNXX OPERATING_SYSTEM=WINNT

HSG80> SET !NEWCONNXX OPERATING_SYSTEM=DIGITAL_UNIX

NOTE

For HP–UX and IBM AIX use default operating system

WINNT. Refer to Section 3.0 of the HP-UX Release Notes,

AA-RFBDC-TE/387370-003 for a detailed description.

2. Recreate or modify the mount points and file system tables to include the new device names

(See Table A-1).

For HP-UX, import all volume groups at this time. Important: DO NOT use SAM to import the

volume groups. This must be done by using HP-UX commands. For example:

# mkdir /dev/vgxx

# mknod /devvgxx/group c 64 0xXX0000

# vgimport -m vgXX.mapfile /dev/vgXX /dev/dsk/c4t0d6

# vgchange -a y /dev/vgXX

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Compaq HSZ80 Guía de instalación Pagina 21