Compaq DS10 Manual de usuario descargar pdf (Pagina 46)

3-18 Installing Linux on Alpha Systems

3.8 Configuring the X Window System

To complete the installation, configure the X Window System:

At the Linux console prompt, enter the following command to configure the

X Window System:

peng3:~ # sax

SaX: searching card...done

SaX: using XF86_3DLabs for configuration

SaX: if not correct set server manually using the -s option

SaX: go up again within 8 seconds [ Ctrl-c to abort ]

sax: .........

SaX: start new XF86_3DLabs server

2. To start the X Window System, enter the following command:

peng3:~ # startx

XFree86 Version 3.3.6 / X Window System

(protocol Version 11, revision 0, vendor release 6300)

Release Date: January 8 1999

If the server is older than 6-12 months, or if your card is

newer

than the above date, look for a newer version before reporting

problems. (see http://www.XFree86.Org/FAQ)

Operating System: Linux 2.2.13 alpha [ELF] SuSE

Configured drivers:

GLINT: accelerated server for 3DLabs GLINT graphics adapters

(Patchlevel 0)

(using VT number 8)

XF86Config: /etc/XF86Config

(**) stands for supplied, (--) stands for probed/default values

(**) XKB: rules: "xfree86"

(**) XKB: model: "pc104"

(**) XKB: layout: "us"

(**) Mouse: type: PS/2, device: /dev/psaux, samplerate: 60

(**) Mouse: buttons: 3

(**) GLINT: Graphics device ID: "Primary-Card"

(**) GLINT: Monitor ID: "Primary-Monitor"

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 61 62

Sin comentarios

Compaq DS10 Manual de usuario Pagina 46