Compaq MPAC-18 Especificaciones descargar pdf (Pagina 13)

STATUS MONITORING

3. Status Monitoring

3.1. Chassis Interface Options

The Active MAXNET II product line can be monitored and controlled in either of two ways:

a) A free, web-based interface. This comes pre-installed on every chassis and provides a user friendly method of

conguring the administrative set-up and all monitoring and control. It is based on SNMP, but requires little knowledge

of SNMP. Any internet browser, such as Internet Explorer, is all the software that is required.

b) Any third-party SNMP Management software (e.g. www.castlerock.com, www.ndt-inc.com/SNMP/MIBrowser.html)

may be purchased separately. These suites tend to be expensive and not as user friendly as the web interface. The

web interface is also still required for administrative set-up. The 3rd party interface is recommended only for systems

that have an existing SNMP architecture. All MIBs (Management Information Bases) are freely downloadable from

the SCTE (www.scte.org/standards). ATX was able to support all modules using the SCTE standard HMS MIBs, so

no custom MIBs are required.

3.2. SCTEHMSMIBSoftwareDenitionofModule

The power supply module uses the headend power supply MIB to support voltage and current measurements of what it is

providing to the chassis’ backplane.

3.3. Web Interface

The MAXNET II chassis uses an integrated web page to supplement the SNMP management. All congurations of the

chassis (static IP address, trap/email recipients, rmware upgrades, etc) must be done through the web page. Simply use

any web browser (Internet Explorer, Firefox, etc) and enter the IP address of the chassis as the URL. Login as administrator

to modify conguration and have full read/write access to monitor and control modules. Login as Operator to have full read/

write access or login as observer to have read-only access. There is only one password per login level.

MAXNET

II – MPAC/MPDC Modular Power Supply – Installation & Operation Manual 3-1

CHAPTER 2: INSTALLATION CHAPTER 3: STATUS MONITORING

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sin comentarios

Compaq MPAC-18 Especificaciones Pagina 13