Compaq MPAC-18 Especificaciones descargar pdf (Pagina 19)

5.2.7. Module Will Not Insert Fully Into Chassis

a) Remove the module and inspect it for damage or bent guide rails.

b) Inspect the chassis for bent metal or obstructions.

c) Be sure that the active module is inserted such that the left side is above an odd numbered slot and the right side

is above an even number slot.

d) Try the module in a different slot. Due to machinery tolerances, some modules may be more snug in some slots

than others. If the tolerances are unacceptable, contact ATX.

5.2.8. Temperature/Fan Fault Alarm on Any MAXNET

II Active Module

Check to see if the module fan is operating. If not replace with a new fan from ATX

(Fan Part #: MPFANA) using the below procedure.

5. Install replacement fan in the opposite order shown. Ensuring that:

a) The red and black wires are aligned.

b) The labelled side of the fan faces inward toward the module.

c) The wires do not bunch up behind the fan, interfering with fan rotation.

MAXNET

II – MPAC/MPDC Modular Power Supply – Installation & Operation Manual 5-3

CHAPTER 5: MAINTENANCE & TROUBLESHOOTING CHAPTER 5: MAINTENANCE & TROUBLESHOOTING

1. Remove two screws holding plate and fan

in place.

2. Remove fan cover and screws.

3. Pull out fan with tweezers.

4. Remove push-t power connections.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Compaq MPAC-18 Especificaciones Pagina 19