Compaq OXYGEN VX1 Manual de usuario descargar pdf (Pagina 20)

3-6 3Dlabs OXYGEN VX1 PCI Graphics Controller Installation Guide

4. Edit the file /etc/dt/config/Xservers and add the appropriate X server

Option, "-screen0" and or "-vsync0" to the line that starts the X server. This

line is generally the last line in the file Xservers.

Example line from the Xservers file used with CDE:

:0 Local local@console /usr/bin/X11/X :0 -screen0 1280x1024

X server Options:

Set screen (W)width and (H)height.

-screen[screen] WxH

Set screen (Hz) Vertical refresh rate

-vsync[screen] Hz

___________________________Note ____________________________

• These are device dependent X server options and not available for ALL graphics

options. See Table 3–1 for supported Resolutions and Refresh Rates.

• Both the Width and Height should be specified in the "-screen" option and not just

the Width. On some X server graphics devices setting ONLY the Width will cause

the X server to fail.

• The [screen] number need not be specified if only one screen exists or if the user

wants all screens to use the same values. The [screen] value is generally '0' as

shown in the example below.

Example:

-screen0 1280x1024

| [screen] value

• Anything added after the "-I" option will be ignored by the X server and passed on

to the DDX, Device Dependent X layer of the server. The "-screen" and or "-

vsync" option(s) should precede the "-I" option.

____________________________________________________________

5. Restart the CDE GUI.

For DIGITAL UNIX V5.* systems use:

# /sbin/init.d/xlogin stop

# /sbin/init.d/xlogin start

Examples of Typical Resolution and Refresh Rate Settings Using CDE

• Setting the Screen Resolution to 1280 x 1024.

:0 Local local@console /usr/bin/X11/X :0 -screen0 1280x1024

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 28 29

Sin comentarios

Compaq OXYGEN VX1 Manual de usuario Pagina 20