Compaq Contec COM-2(PC)F Manual de usuario descargar pdf (Pagina 20)

How to Use the Board

COM-2(PC)F 11

Compatible Mode Installation Procedure 1

1. Set the operation mode (I/O address) and interrupt level for the

COM-2(PC)F. Set the COM-2(PC)F switch and jumpers as

described in Hardware Setup. Set an interrupt level that is not

currently used by the computer.

2. Insert the COM-2(PC)F in an expansion slot and turn on the

power to the PC.

3. After Windows 95 starts, select [Control Panel] from

[My Computer] and start the [Add New Hardware].

4. Click [Next >] in response to [To begin installing your new

hardware, click Next] in the Add New Hardware Wizard.

5. Select [Yes (Recommended)] in response to [Do you want

Windows to search for your new hardware ?].

6. After following the instructions and completing detection, use

[Details...] to check that the standard serial ports have been

detected.

7. Next, click [Finish] and restart your computer.

8. After rebooting, use the procedure described in the "Check

Resources" section below to check the interrupt level assigned

to the COM-2(PC)F. If the value is different to the level set on

the jumper, correct the setting in the OS.

9. When installing by this method, the COM-2(PC)F channels are

installed as standard serial ports (COM*).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 76 77

Sin comentarios

Compaq Contec COM-2(PC)F Manual de usuario Pagina 20