Compaq 1500 Guía para resolver problemas Pagina 56
- Pagina / 217
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Troubleshooting 3-29
Table 3-28
Solving Screen Problems
Problem Probable Cause Solution(s)
Characters are dim. The brightness or contrast
(if applicable) control is not
set properly.
Adjust the control(s)using Fn+F9
(contrast) and Fn+F10 (brightness).
Computer screen is in direct light. Tilt the display or move computer.
Display is damaged. Replace the display.
Screen is blank. You initiated QuickLock/
QuickBlank.
Enter the password to exit
QuickLock/QuickBlank.
You may have another screen -
blanking utility installed.
Press any key and/or enter the
password.
Screen save was initiated after
the Power Management timeout
period of inactivity
Press any key or click the mouse.
If an STN screen is used, brightness/
contrast needs adjusting.
Use the hotkeys to adjust the
brightness/contrast.
Screen has overheated If the computer is in direct sunlight,
move it an allow it to cool.
Suspend was initiated. Press the suspend button to exit
Suspend.
Computer screen is blank and
the screen on an external
monitor displays information.
Display was switched to the
external monitor.
Press the Fn+F4 hotkey to display
information on the computer screen.
Screen is blank and the
power/suspend light is blinking
System is in Suspend Press the Suspend button to exit
Suspend. Enter the power-on
password if prompted.
Screen is blank, the power/
suspend light is blinking, and
the battery light is blinking
System has entered a low-battery
condition
Immediately connect the computer to
an external power source or replace
the battery pack.
External monitor does not
display information
External monitor was connected after
the computer was turned on
Press the Fn+F4 hotkey to switch to
the external monitor
The external monitor signal cable
or power cord is not properly
connected.
Verify the cables are properly
connected.
Distorted or garbled characters
on the screen are mixed with text.
The ANSI.SYS driver is not in the
CONFIG.SYS file or the path is
incorrect.
Add the ANSI.SYS driver to the
CONFIG.SYS file. Add the following
line: DEVICE=C:\ANSI.SYS
Garbled characters on internal
display or flashing internal display
when connected to external
monitor.
You are using 800 × 600 or higher
resolution on external display and
have toggled back to internal display,
which only supports
640 × 480 resolution.
Restart the computer. If simultaneous
display is desired, use 640 × 480
resolution.
The image on the external
monitor does not fill the screen.
You are using an external monitor
and simultaneously displaying an
image on the computer display.
This is typical; no action is required.
Small red, green, or blue spots
appear on the computer TFT
display.
Small spots, called on-pixels, often
appear on TFT screens. Compaq
limits the number of these on-pixels
to 0.003% of the approximately
1 million transistors that are on a
12.1-, or 11.3-inch display.
This is typical; no action is required.
When in MS-DOS mode,
the image on the computer
display does not fill the screen.
When displaying simultaneously,
the image on the external
monitor may not be centered.
To maintain a high-quality image, the
800 × 600 models do not
stretch the lower-resolution
image of MS-DOS mode to fill the
screen.
This is typical; no action is required.
- Maintenance and Service Guide 1
- Technician Notes 2
- Laser Safety 3
- CDRH Regulations 3
- Battery Notice 4
- Serial Number 4
- Contents 6
- Chapter 7 8
- Chapter 8 9
- Chapter 9 9
- Contents ix 10
- Computer Product Description 11
- 1.2 Standard Features 12
- 1.2.1 Software Fulfillment 13
- 1.3 Options 14
- 1.3.4 External Keyboards and 15
- Pointing Devices 15
- 1.3.5 External Monitors 15
- 1.4.2 Right Side Components 17
- 1.4.3 Rear Components 18
- 1.4.4 Bottom Components 19
- 1.4.5 Status Panel Lights 20
- Description 21
- 2.3.2 Rear Components 26
- Troubleshooting 28
- 3.1 Preliminary Steps 29
- Troubleshooting 3-3 30
- 3.4 POST Error Messages 31
- Table 3-1 32
- Warning Messages 32
- Table 3-2 33
- Fatal Error Messages 33
- Table 3-3 33
- Fatal Error Beep Codes 33
- 3.5 Compaq Utilities 34
- 3-8 Troubleshooting 35
- Computer Checkup 36
- 3-10 Troubleshooting 37
- 3.6 Diagnostic Error Codes 38
- 3-12 Troubleshooting 39
- Troubleshooting 3-13 40
- Table 3-11 41
- Video Test Error Codes 41
- Table 3-12 42
- Audio Test Error Codes 42
- Table 3-13 43
- Table 3-14 43
- CD-ROM Test Error Codes 43
- 3.7.1 Solving Minor Problems 44
- Table 3-16 45
- Troubleshooting 3-19 46
- Table 3-17 47
- Solving Hard Drive Problems 48
- Solving CD-ROM Drive Problems 48
- Table 3-20 49
- Table 3-21 49
- Table 3-22 50
- Table 3-23 50
- Solving Memory Problems 51
- Solving PC Card Problems 52
- Table 3-25 Continued 53
- Solving Power Problems 54
- Solving Printer Problems 55
- Solving Screen Problems 55
- Table 3-28 56
- Table 3-29 57
- Troubleshooting 3-31 58
- 3-32 Troubleshooting 59
- Solving Network Problems 60
- 3-34 Troubleshooting 61
- 4.1 System Unit 63
- 4.2 Mass Storage Devices 65
- 4.3 Cables and Power Cords 67
- 4.5 Options 71
- 4.6 Miscellaneous Parts 73
- 4.8 Shipping Boxes 75
- 4.9 Documentation 75
- 5.1 System Unit 77
- Removal and Replacement 79
- Preliminaries 79
- Equipment 80
- Removing Batteries 80
- Preventing Damage to Drives 81
- Grounding Methods 81
- Grounding Workstations 82
- Grounding Equipment 82
- 6.2 Service Considerations 84
- 6.3 Serial Number 84
- Procedures 85
- 7.3 Design Overview 87
- 7.3.3 Video system 88
- 7.4.2 Undocking the Computer 89
- 7.4.3 Battery Pack 90
- To install the battery pack: 91
- 7.4.4 DualBay Devices 92
- 7.4.5 PCMCIA 93
- 7.5 Modem 94
- 7.6 CD-ROM Drive 95
- 3. Remove the CD-ROM drive 96
- 7.7 Keyboard 97
- 7.8 Memory Board 100
- 7.9 Hard Drive 103
- 7.10 Lithium Real Time Clock 105
- 8. Remove the RTC battery 106
- Cover and Microphone 107
- 5. Remove the microphone 109
- 7.12.1 Clutch Covers 110
- 7.12.2 Display Assembly 111
- 7.12.3 Clutches 112
- 5. Remove the display bezel 113
- 7. Remove the display clutch 115
- 7.12.4 Display latches 116
- 7.13 Top Cover Assembly 118
- 7.13.1 Power Button 120
- 7.13.2 Suspend Button 121
- 7.14 LED Status Panel 124
- 7.16 DC-DC Converter 127
- 7.17 Fan 131
- Figure 7-42. Removing the Fan 132
- 7.18 I/O Fixture Connector 133
- 7.19 System Board 135
- 7.20 AC Power 137
- 7.21 External Computer 138
- Components 138
- 7.21.2 Computer Feet 138
- Upgrade Procedures for the 139
- Convenience Base 139
- Ethernet Network Module 140
- 5. Remove the 10BaseT module 144
- Specifications 148
- 9.1 Computer 149
- 9.2 Displays 150
- 9.3 Hard Drives 151
- 9.4 Diskette Drive 152
- 9.5 CD-ROM Drive 153
- 9.6 Battery Packs 154
- 9.7 Convenience Base 155
- 9.8 External Power Supplies 156
- Table 9-11 157
- External Battery Charger 157
- 9.9 System Interrupts 158
- 9.10 System DMA 158
- 9.11 System I/O Address 159
- Table 9-17 Continued 160
- 9.12 System Memory Map 161
- Table A-7 164
- Parallel 164
- Table A-8 164
- Table A-9 165
- Expansion Connector 165
- Table A-9 Continued 166
- Table A-10 168
- Speaker Connector 168
- Power Cord Set Requirements 169
- Country-Specific Requirements 170
- Modem Commands 171
- Table C-1 Continued 172
- Command Description 172
- Table C-2 175
- AT Commands 175
- Table C-2 Continued 176
- Table C-3 178
- Fax Commands 178
- Table C-3 Continued 179
- Table C-4 181
- Dial Modifiers 181
- 1.1 Models and Features 184
- 1.2 Features 185
- 1.3 Software Fulfillment 186
- Universal Serial Bus 187
- Battery Spacer Door 187
- Illustrated Parts for the 188
- Computer 188
- Table 4-1 189
- System Unit 189
- Table 4-2 190
- Mass Storage Devices 190
- Table 4-3 191
- Cables and Power Cords 191
- Table 4-4 192
- Standard and Optional Boards 192
- Table 4-5 193
- Table 4-6 194
- Miscellaneous Parts 194
- Table 4-7 195
- Accessories 195
- Option Spares 196
- 9.0 Specifications 197
- Physical Configuration 198
- Random < 150 ms 199
- Table 9-3 200
- 12.1-inch TFT, SVGA Display 200
- Appendix C 201
- Continued 201
- Continued 205
- Index I-1 214
- I-2 Index 215
- Index I-3 216
- I-4 Index 217
Relacionado con productos y manuales para Cuadernos Compaq 1500
Cuadernos Compaq 272637-001 Información técnica
(55 paginas)
(55 paginas)
Cuadernos Compaq Armada 1700 Información técnica
(189 paginas)
(189 paginas)
(3 paginas)
(13 paginas)
Cuadernos Compaq N150 Series Especificaciones
(89 paginas)
(89 paginas)
Cuadernos Compaq CQ10-550 Información técnica
(101 paginas)
(101 paginas)
Cuadernos Compaq Presario 6500 Información técnica
(150 paginas)
(150 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.169 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales