
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6-6 Removal and Replacement Preliminaries
6.2 Service Considerations
Listed below are some considerations to keep in mind during the disassembly and
assembly of the computer.
Tool Requirements
■ Magnetic Torx T-8 screwdriver
■ Flat-bladed screwdriver (optional)
Tool kit, Compaq part number 100767-001 (includes case utility tool, connector
removal tool, and loop back plugs)
■ 7-mm socket wrench
■ 5-mm socket wrench/screw driver
■ Preloaded application diskettes
IMPORTANT: To reassemble the computer, set the Torx T-8 screwdriver to
3-inch lbs.
Cables and Connectors
Apply only the tension required to seat or unseat the cables during insertion or removal
from connectors. Handle cables by the connector or pull tabs whenever possible. In all
cases, avoid bending, twisting, or tearing the cables, and ensure that cables are placed in
such a way that they cannot be caught or snagged by parts being removed or replaced.
CAUTION: When servicing these computers, ensure that cables are placed in
their proper location during the reassembly process. Improper cable placement
can cause severe damage to the unit.
6.3 Serial Number
The computer serial numbers should be provided to Compaq whenever requesting
information or ordering spare parts. The serial number is located on the rear of the CPU.
Comentarios a estos manuales