Compaq 380 Especificaciones descargar pdf (Pagina 23)

Removal and Replacement Procedures 2-11

Tape Drive Blank

To remove the tape drive blank:

1. Remove the hot-plug SCSI hard drive or hard drive blank in the bay below the tape drive

blank:

G If a hot-plug SCSI hard drive is installed in the bay, see the “Hot-Plug SCSI Hard

Drive” section in this chapter.

G If a hard drive blank is installed in the bay, see the “Hard Drive Blank” section in this

chapter.

2. Squeeze the middle of the tape drive blank .

3. Pull to remove the blank .

Figure 2-8. Removing the tape drive blank

CAUTION: Always populate the tape drive bay with either a tape drive or hard drive blank and

tape drive blank. Operating the server without installing a tape drive or blank results in

improper airflow and improper cooling that can lead to thermal damage.

To replace the tape drive blank, slide the blank into the bay until it locks into place.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 120 121

Sin comentarios

Compaq 380 Especificaciones Pagina 23