Compaq 380 Especificaciones descargar pdf (Pagina 61)

Removal and Replacement Procedures 2-49

PPMs

To remove a PPM:

1. Power down the server. See the “Powering Down the Server” section in this chapter.

2. Extend or remove the server from the rack. See the “Preparation Procedures” section in

this chapter.

3. Remove the access panel. See the “Access Panel” section in this chapter.

4. Open the latches on the sides of the PPM slots .

5. Lift the PPM out of the slot .

Figure 2-49. Removing a PPM

CAUTION: PPM slots must be populated when processors are installed. If PPM slots are not

populated, the system does not boot.

IMPORTANT: PPMs do not seat if turned the wrong way.

Reverse steps 1 through 5 to replace the PPM.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 120 121

Sin comentarios

Compaq 380 Especificaciones Pagina 61