Compaq StorageWorks 2/24 - Edge Switch Guía de instalación descargar pdf (Pagina 63)

edge switch 2/32 installation guide 2-37

Installing and Configuring the Edge Switch 2/32

Figure 2–24: Configure Addresses—Active dialog box

a. Select a blank Name field and type a descriptive port name of 24 or fewer

alphanumeric characters. Use a name that reflects the device connected to the

port.

b. Click Blocked to block or unblock a port. A check mark in the box indicates

the port is blocked. Blocking the port prevents the attached device from

communicating with the switch. A blocked port continuously transmits the

offline sequence (OLS).

2. The yellow shaded area of the dialog box (matrix) represents a rectangular array

of port addresses used to configure connections. The default state is an empty cell

representing an allowed connection between two port addresses.

a. Click a blank matrix cell to prohibit the connection of the two intersecting

ports. A prohibited connection is indicated by a red circle with a slash in the

cell.

b. Click a prohibited matrix cell to clear the restriction and allow the connection

of the two intersecting ports.

c. Right-click a matrix cell to display a menu that provides the following port

configuration selections:

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 143 144

Sin comentarios

Compaq StorageWorks 2/24 - Edge Switch Guía de instalación Pagina 63