Compaq AlphaServer ES45 3B Especificaciones descargar pdf (Pagina 139)

Configuring and Installing Components 4-29

WARNING: To prevent injury, access is limited to persons who

have appropriate technical training and experience. Such per-

sons are expected to understand the hazards of working within

this equipment and take measures to minimize danger to them-

selves or others.

WARNING: Do not remove memory modules until the green

LEDs are off (approximately 20 seconds after a power-down).

WARNING: Modules have parts that operate at high

temperatures. Wait 2 minutes after power is removed

before touching any module.

WARNING: To prevent injury, unplug the power

cord from each power supply before installing com-

ponents.

1. Shut down the operating system and turn off power to the system. Unplug

the power cord from each power supply.

2. Access the system chassis by following the instructions in Section 4.2.

3. Remove the fan cover and the system card cage cover.

4. Use Figure 4–11 or Figure 4–12 to determine where sets of memory DIMMs

should be installed. Begin with the next available lowest set.

5. Release the clips

securing the appropriate MMB and slide out the

MMB. See Figure 4–13.

6. Release the clips

on the slot where you will install the DIMM.

See Figure 4–14.

Continuedonnextpage

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 321 322

Sin comentarios

Compaq AlphaServer ES45 3B Especificaciones Pagina 139