Compaq ProLiant BL20p Guía de instalación descargar pdf (Pagina 94)

LEDs and Switches

Compaq ProLiant BL20p Server Blade Setup and Installation Guide E-9

COMPAQ CONFIDENTIAL

Writer: Christine Portillo File Name: i-appe LEDs and Switches.doc

Codename: AvX Part Number: 307131-001 Last Saved On: 11/1/02 1:06 PM

iLO Switch (SW2)

The iLO switch is a four-position switch that grants you access to perform a boot

block flash of system ROM and iLO ROM. For the proper system configuration

switch settings, refer to Table E-4 or refer to the labels attached to the inside of the

server access panel.

Table E-4: iLO Switch (SW2) Settings

Position Description On/Off Function

1 Reserved —

2 ILO security

override

Off = iLO security is enabled; iLO

access requires a valid user ID and

password. Also, the iLO boot block

access is disabled and the iLO boot

block cannot be flashed.

On = iLO security is disabled; iLO

access is possible without a valid user

ID or password. Also, the iLO boot

block access is enabled and the iLO

boot block can be flashed.

3 Reserved —

4 Reserved —

System Switch (SW3)

The function for this switch is reserved.

CAUTION: Do not change any SW3 settings or the system may not function

properly.

System Configuration Switch (SW1)

The system configuration switch is a four-position switch that enables access to

server hardware settings. The default setting for all four positions is off. For the

proper system configuration switch settings, refer to Table E-5 or refer to the labels

attached to the inside of the server access panel.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 107 108

Sin comentarios

Compaq ProLiant BL20p Guía de instalación Pagina 94