Compaq StorageWorks 6000 - Virtual Library System Guía de usuario descargar pdf (Pagina 202)

Configuration Commands

Use the CLI commands in CLI configuration commands to:

• Edit the Fibre Channel host port settings

• Enable oversubscription and view oversubscription settings

• View LUN mapping

• Create, view, and destroy virtual libraries, tape drives, or cartridges

• Add, view, or remove barcode templates

Table 9 CLI configuration commands

Usage

Command

Add a node to the VLS. See getNodeNames.addNode

Discovers any new arrays added to the VLS.

discoverArray

Changes the default FC host port connection settings. Where the options are:

-a <n> - ID number of node to modify (0, ...) (optional)

-i <n> - FC index (0, 1, ...) (required)

-l <n> - If attached in arbitrated loop mode, specifies a hard ALPA value between

0 and 125. A value of -1 specifies a dynamically assigned ALPA. If not attached

to an arbitrated loop, this parameter is ignored (required)

-r <n> - Port number of the FC port to modify (required)

-s <n> - Preferred speed (0-Auto, 1-One GB, 2-Two GB, 4-Four GB, or 10-Ten

GB) (required)

-t <n> - Preferred topology (0-Auto, 1-Point to Point, 2-Loop, 3-Fabric, or 4-Public

Loop) (required)

-h - Displays command usage information (optional)

updateFC

Enables or disables oversubscription and specifies the percent storage remaining

for notification. Where the options are:

-e <n> - Enable/disable oversubscription (0-Disabled or 1-Enabled) (required)

-p <n> - Percentage of capacity remaining for alert notification (required)

-h - Displays command usage information (optional)

setOverSubscription

Returns whether the oversubscription feature is enabled or disabled and the capa-

city remaining percentage for notification alert. Oversubscription is enabled when

enabled = 0. Oversubscription is disabled when enabled = 1.

getOverSubscription

Returns a list of available library emulation types. Displays each library emulation's

name, type, product, revision, and vendor information. Where the options are:

-l - List only licensed types (optional)

-h - Displays command usage information (optional)

getLibTypes

CLI Command Set202

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 357 358

Sin comentarios

Compaq StorageWorks 6000 - Virtual Library System Guía de usuario Pagina 202