Compaq StorageWorks 6000 - Virtual Library System Guía de usuario descargar pdf (Pagina 257)

• Remove the node access panel. See Removing the VLS Node Access Panel, Removing a VLS Node

from the Rack, or Removing the VLS Node Access Panel.

If you must remove a component located inside the node, remove the access panel.

Locating and Removing the Torx T-15 Tool (VLS6800 node only)

1. Locate the Torx T-15 tool on the back of the node.

2. Slide the tool upward out of the retaining clips.

Figure 71 Removing the Torx T-15 tool

Extending a VLS6100, VLS6200, or VLS6500 Node from the Rack

WARNING!

To reduce the risk of personal injury or equipment damage, be sure that the rack is adequately

stabilized before extending a node from the rack.

WARNING!

Be careful when pressing the rail-release levers and sliding the component into or out of the rack. The

sliding rails could pinch your fingertips.

To extend a node from the rack:

1. Loosen the thumbscrews that secure the node faceplate to the front of the rack.

2. Extend the node on the rack rails until the node rail-release latches engage.

3. After performing the replacement procedure, slide the node back into the rack:

a. Press the node rail-release latches and slide the node fully into the rack.

b. Secure the node by tightening the thumbscrews.

HP StorageWorks 6000–series Virtual Library System User Guide 257

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 357 358

Sin comentarios

Compaq StorageWorks 6000 - Virtual Library System Guía de usuario Pagina 257