Compaq 2000fc Guía para resolver problemas descargar pdf (Pagina 37)

Quick Troubleshooting Guide A-7

Hardware Installation

You may need to reconfigure the computer when you add or remove hardware, such as an

additional diskette drive. If you install a Plug and Play device, Windows 95 automatically

recognizes the device and configures the computer. If you install a non-Plug and Play device, you

must reconfigure the computer after completing installation of the new hardware. In Windows 95,

select the Add New Hardware icon in the Control Panel and follow the instructions that appear on

the screen. To reconfigure the computer in Windows NT Workstation 4.0 after installing new

hardware, use the utility provided with the hardware.

Problem Possible Solutions

A new device is not

automatically recognized as

part of the computer system.

1. The computer needs to be reconfigured to recognize the new

device. Follow the reconfiguration instructions above. If system

still does not recognize the new device, but the device is listed

within Computer Setup, use Computer Setup to address any

resource conflicts.

2. When the system advised you of changes to the configuration,

you did not accept them. Reboot the computer and follow the

instructions for accepting the changes.

3. A Plug and Play board may not automatically configure when

added if the default configuration conflicts with other devices. Use

Windows 95 Device Manager to deselect the automatic settings

for the board and choose a basic configuration that doesn’t cause

a resource conflict. You can also use Computer Setup to

reconfigure or disable devices to resolve the resource conflict.

4. The cables for the new external device are loose or the power

cables are unplugged. Check all cables, and check that pins in the

cable or connector are not bent down.

5. The power switch for the new external device is not turned on.

Turn off the computer, turn on the external device, and then turn

the computer on to integrate the new device with the computer.

6. If the drive is a secondary drive that has just been installed on the

same controller as the primary drive, verify that the jumpers for

both drives are set correctly.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Sin comentarios

Compaq 2000fc Guía para resolver problemas Pagina 37