Compaq 2000fc Guía para resolver problemas descargar pdf (Pagina 43)

Quick Troubleshooting Guide B-1

appendix

POST ERROR MESSAGES

An error message results if the Power-On Self-Test (POST) encounters a problem. This test runs

when the system is turned on, checking assemblies within the computer and reporting any errors

found.

Screen Message Beeps* Probable Cause Recommended Action

101-Option ROM Error 1L, 1S System ROM checksum. 1. Verify the correct ROM.

2. Flash the ROM if needed.

3. If an expansion card was

recently added, remove it and

see if the problem remains.

4. If the message disappears,

there may be a problem with

the expansion card.

5. Replace the system board.

102-System Board

Failure

None DMA, timers, etc. 1. Clear CMOS.

2. Remove expansion boards.

3. Replace the system board.

103-System Board Failure None DMA, timers, etc.

1. Clear CMOS.

2. Remove expansion boards.

3. Replace the system board.

162-System Options

Not Set

2S Configuration incorrect.

RTC (real-time clock)

battery may need to be

replaced. Battery life is

approximately 5 years.

Run Computer Setup (F10 Setup)

Reset the date and time under

Control Panel. If the problem

persists, replace the RTC battery.

163-Time & Date Not Set 2S Invalid time or date in

configuration memory.

RTC (real-time clock)

battery may need to be

replaced. Battery life is

approximately five years.

CMOS jumper may not

be properly installed.

Set the date and time under

Control Panel.

If the problem persists, replace the

RTC battery.

Check for proper placement of the

CMOS jumper.

* L = Long, S = Short

continued

Click Here to Find Error Code

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Comentarios a estos manuales

Sin comentarios

Compaq 2000fc Guía para resolver problemas Pagina 43

Comentarios a estos manuales

Relacionado con productos y manuales para Barebones Pc / Estación De Trabajo Compaq 2000fc