Compaq ProLiant Especificaciones descargar pdf (Pagina 18)

Removal and Replacement Procedures 2-5

Front Bezel

WARNING: To reduce the risk of personal injury and to prevent damage to the equipment,

before removing the front bezel, make sure that the server is powered down, all cables are

disconnected from the back of the server, and the power cord is disconnected from the

grounded (earthed) AC outlet.

To remove the front bezel:

1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.

2. Pull forward on the latch at the bottom of the front bezel

3. Swing the front bezel upward, and then slide it out and away from the chassis

Figure 2-1. Removing the front bezel

NOTE: When replacing the front bezel, ensure that the top hinge points are properly placed in the

chassis before rotating the front bezel back into its original position.

NOTE: Intruder Alert enables and disables the intruder alert option. When enabled, an intruder alert

message is displayed if the front bezel has been unlatched or removed. The default setting is disabled.

To replace the front bezel, reverse steps 2 and 3.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 77 78

Sin comentarios

Compaq ProLiant Especificaciones Pagina 18