Compaq ProLiant Especificaciones descargar pdf (Pagina 40)

Removal and Replacement Procedures 2-27

Server Feature Board

To remove a Server Feature Board:

1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.

2. Remove the front bezel. See “Front Bezel” earlier in this chapter.

3. Remove the access panel. See “Access Panel” earlier in this chapter.

4. Disconnect any cables connected to the Server Feature Board.

5. Remove the screw securing the Server Feature Board to the chassis

, and then pull the

Server Feature Board out of the server

Figure 2-24. Removing the Server Feature Board

NOTE: The Server Feature Board is located only in slot 3.

To replace the Server Feature Board, reverse steps 2 through 5.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 77 78

Sin comentarios

Compaq ProLiant Especificaciones Pagina 40