Compaq ProLiant Especificaciones descargar pdf (Pagina 30)

Removal and Replacement Procedures 2-17

Fan

To remove the fan:

1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.

2. Remove the front bezel. See “Front Bezel” earlier in this chapter.

3. Remove the access panel. See “Access Panel” earlier in this chapter.

4. Disconnect the fan power cable from the system board fan connector

5. Use a Phillips screwdriver to remove the four mounting screws from the rear of the

server

6. Pull the fan out and away from the chassis .

Figure 2-13. Removing the fan

To replace the fan, reverse steps 2 through 6.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 77 78

Sin comentarios

Compaq ProLiant Especificaciones Pagina 30