Compaq ProLiant Especificaciones descargar pdf (Pagina 42)

Removal and Replacement Procedures 2-29

System Board

CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure that you

are properly grounded (earthed) before beginning any installation procedure. See “Electrostatic

Discharge Information” earlier in this chapter for more information.

To remove the system board:

1. Complete the preparation procedures. See “Preparation Procedures” earlier in this chapter.

2. Remove the front bezel. See “Front Bezel” earlier in this chapter.

3. Remove the access panel. See “Access Panel” earlier in this chapter.

4. Remove all expansion boards seated on the system board.

5. Disconnect all cables from the system board.

6. Remove the ten screws securing the system board to the chassis

7. Pull the system board out of the chassis

Figure 2-26. Removing the system board

To replace the system board, reverse steps 2 through 7.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 77 78

Sin comentarios

Compaq ProLiant Especificaciones Pagina 42