Compaq VAX 7000 Guía de instalación Pagina 39

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 50
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 38
14.1.10 VAX 7000 and HSJ40, Single Path Booting Problem
As described in Section 14.1.11, a VAX 7000 will not boot from an HSJ40 disk if one path
to the HSJ40 controller is disabled. Unfortunately, this configuration is needed as a work-
around for the HSJ40 "dual receive crash" problem.
The following console patch allows the VAX 7000 to boot over a single path. It should only
be installed on systems that boot from an HSJ40 system disk and have console version V3.2-
4041[A6] .Itmust be removed when the console is upgraded. (Use >>> build eeprom, to
erase patch).
Execute the following commands to install the patch.
>>> set mode advanced
>>> set eeprom script powerup
Script> set mode advanced
Script> ka7aa_pwrup
Script> echo "Applying single path boot patch to V3.2-4041[A6]" > tt
Script> d -w 2DBA6 2811 -u
Script> d -l 2dbce 05B13511 -u
Script> d -l 2dbd2 B1471350 -u
Script> d -l 2dbd6 42135011 -u
Script> d -l 2dbda A0C401E0 -u
Script> d -l 2dbde CA11DA00 -u
Script> Set mode basic
Script> ^Z
>>> Set mode basic
On multi processor systems use this command to update the other CPUs:
P00>>> update ka7aa* -e
This message pops out at Initialise time to tell you the patch is being applied.
14.1.11 VAX 7000 fails to reboot from HSJ-40 devices
VAX 7000 V2.X and V3.0, V3.1 consoles don’t handle the virtual circuit with the HSC-40
properly when attempting to reboot. This causes the boot to fail like this:
P00>>>
Booting...
Connecting to boot device dua403.10.0.13.0
Created device: dua403.10.0.13.0
device dua403.10.0.13.0 not found
failed to open dua403.10.0.13.0
P00>>>
The fix is to install VAX7000 Console V3.2. Note a problem still exists when attempting to
SHOW DEVICE or boot a drive with PATH A or B disconnected or disabled from an HSJ-
40. You must have both paths enabled and connected for the console code to work properly.
Alternatively, see Section 14.1.10.
39
Vista de pagina 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 49 50

Comentarios a estos manuales

Sin comentarios