Compaq Compaq Portable II Especificaciones descargar pdf (Pagina 53)

Chapter 7. Removal and Replacement Procedures

Chapter 7.1 Introduction

Before starting removal procedures, review Chapter 6, "Illustrated Parts

Catalog," to become familiar with the various part names and locations.

Removal and replacement procedures in this section are written generically for

all COMPAQ Portable Computers, except in cases where procedures differ

because of design differences. These differences affect the removal and

replacement procedures for the power supply subsystem and the monitor

enclosure. When procedures differ, specific instructions are given.

Also note that when you are instructed to cut a tie wrap for removal of an

assembly, you should also replace the tie wrap for reassembly.

NOTE: Run the latest version of COMPAQ DIAGNOSTICS to verify the proper

operation of the replaced component.

Chapter 7.2 Preparation Procedure

Before beginning the procedures in this section, complete the following steps:

1. Place the ON/OFF switch (on the side of the computer) in the OFF position.

2. Close the keyboard and secure it in place by sliding the latches to the

LOCK position. Fold the keyboard feet in place. (Figure 7.2-1).

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 128 129

Sin comentarios

Compaq Compaq Portable II Especificaciones Pagina 53