Compaq Compaq Portable II Especificaciones descargar pdf (Pagina 74)

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

CAUTION

Pull only on the connector, do not pry. Pulling on the wires makes the

connector grip the pins tighter, which will damage the connector.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

3. Using the special two piece socket tool or 5/16 inch box end wrench,

loosen the power supply mounting screw from the upper (or lower) right

corner of the power supply assembly (Figure 7.8-20).

4. Partially close the access door panel to allow the standoffs to disengage

the chassis.

5. Slide the power supply assembly toward the back of the chassis until the

board standoffs disengage. This releases the power supply assembly

from the chassis.

6. Carefully lift the power supply assembly out of the chassis and gently

disconnect the remaining connector from the board (Figure 7.8-21).

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 128 129

Sin comentarios

Compaq Compaq Portable II Especificaciones Pagina 74