Compaq Compaq Portable II Especificaciones descargar pdf (Pagina 81)

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

CAUTION

Pull only on the connector, do not pry. Pulling on the wires damages the

cable.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

4. Gently pull the video display controller board up and out of its socket

(J102 on COMPAQ PORTABLE 286 Personal Computers; J104 on COMPAQ Portable

and COMPAQ PLUS Personal Computers) on the system board and out of the

computer (Figure 7.9-5).

To replace the video display controller board, reverse Steps 1 through 4.

NOTE: Be sure that the board is in the board guide on the left.

Diskette/Tape Controller Board Removal and Replacement

To remove the diskette/tape controller board:

1. Complete the Board Slots Access Plate Removal procedure (see Section 7.4).

2. Disconnect the fixed disk drive controller board signal cables, if

installed (Figure 7.9-2).

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 128 129

Sin comentarios

Compaq Compaq Portable II Especificaciones Pagina 81