Compaq 370 Guía de instalación descargar pdf (Pagina 100)

Installing Hardware Options 4-21

Compaq Confidential – Need to Know Required

Writer: Gilbert Saldivar Project: Compaq ProLiant ML370 Setup and Installation Guide Comments:

Part Number: 120137-002 File Name: e-ch4 Installing Hardware Options Last Saved On: 12/10/99 12:22 PM

Installing a Half-Height Device

You can install up to two half-height devices such as a tape drive in the media

bay:

1. Unscrew and remove a bay blank as illustrated in the previous section.

2. Slide the tape drive into the open bay as show in the figure below and

replace screws to secure the drive to the chassis.

NOTE: Some half-height devices require an additional tray or bay adapter for installation.

Order trays or other adapters from your Compaq authorized reseller.

Figure 4-18. Installing a half-height tape drive in the removable media area

3. Attach one connector of the three-device SCSI cable to the SCSI port on

the rear of the tape drive and the other end of the cable to SCSI port 1.

Refer to Chapter 5, “SCSI Cabling Instructions,” for addition cabling

information.

4. Attach the power connector to the rear of the tape drive.

5. Run the System Configuration Utility and load the appropriate drivers

for your device.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 185 186

Sin comentarios

Compaq 370 Guía de instalación Pagina 100