Compaq Compaq Portable II Guía para resolver problemas descargar pdf (Pagina 109)

To replace the mass storage device enclosure, reverse steps 1 through 10.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

CAUTION

Be sure the LED/speaker and keyboard cables are not pinched or exposed when

replacing the mass storage devices enclosure.

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

Chapter 8.21 LED/Speaker Cable, Keyboard Cable, and LED Assembly

To remove the LED/speaker cable, keyboard cable, and LED assembly:

1. Complete the preparation procedure (see Section 8.2).

2. Remove the rear panel (see Section 8.4).

3. Remove the interface connector cover, if installed (see Section 8.5).

4. Remove the 32 bit memory/modem interface board, if installed

(see Section 8.8).

5. Remove the system board (see Section 8.14).

6. Remove the mass storage device subassembly (see Section 8.16).

7. Remove the mass storage device enclosure (see Section 8.20).

8. Locate the keyboard cable connector shown in Figure 8-59.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 165 166

Sin comentarios

Compaq Compaq Portable II Guía para resolver problemas Pagina 109