Compaq Compaq Portable II Guía para resolver problemas descargar pdf (Pagina 131)

NOTE: For future replacement, notice the proper orientation of the display

power cable assembly and the display data cable assembly.

To replace the display data cable assembly, reverse steps 1 through 13.

Chapter 8.27 Handle and Spreader Plate

To remove the handle and spreader plate:

1. Complete the preparation procedure (see Section 8.2).

2. Remove the rear panel (see Section 8.4).

3. Remove the interface connector cover, if installed (see Section 8.5).

4. Remove the 32 bit memory/modem interface board, if installed (see

Section 8.8).

5. Remove the system board assembly (see Section 8.14).

6. Remove the mass storage device subassembly (see Section 8.16).

7. Remove the mass storage device enclosure (see Section 8.20).

NOTE: The handle can be removed at this point. To remove the handle and

spreader plate, proceed with the following steps.

8. Remove the display enclosure (see Section 8.25).

9. Locate the plasma display hinges shown in Figure 8-94.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 165 166

Sin comentarios

Compaq Compaq Portable II Guía para resolver problemas Pagina 131