
Installing Components 8-17
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: Compaq AlphaServer DS20E System Comments:
Part Number: ER-K8F6W-UA .A01 File Name: i-ch8 Installing Components.doc Last Saved On: 10/4/99 2:40 PM
To Remove an Option Module
1. Remove the side panel (or top cover for a rackmount) as described in
“Preparing to Install or Remove Components.”
2. Disconnect any cables connected to the external (rear) or internal ports
on the option module you want to remove.
3. Remove the slot cover screw securing the option module to the chassis.
4. Carefully disconnect the option module from the slot connectors on the
system board and remove it from the system.
5. If you intend leaving the option slot vacant, install a slot cover and
secure it to the chassis using the screw that you removed.
6. Replace the side panel (or top cover for a rackmount) as described in
“Preparing to Install or Remove Components.”
CAT0037
Figure 8-10. Installing or Removing an Option Module
Comentarios a estos manuales