
Using the SRM Console 11-55
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: AlphaServer DS20E System Comments:
Part Number: ER-K8F6W-UA .A01 File Name: l-ch11 Using the SRM Console.doc Last Saved On: 10/4/99 2:05 PM
Table 11-7
Settings for Boot_osflags Bootflags (OpenVMS)
Flag_Value Bit Number Meaning
1 0 Bootstrap conversationally (enables you to modify
SYSGEN parameters in SYSBOOT).
2 1 Map XDELTA to running system.
4 2 Stop at initial system breakpoint.
8 3 Perform diagnostic bootstrap.
10 4 Stop at the bootstrap breakpoints.
20 5 Omit header from secondary bootstrap image.
80 7 Prompt for the name of the secondary bootstrap file.
100 8 Halt before secondary bootstrap.
10000 16 Display debug messages during booting.
20000 17 Display user messages during booting.
com*_baud
The default baud rate for the system is 9600. With the com*_baud
environment variable, you can set the baud rate to match that of the device
connected to the port.
You will be asked to confirm the change, as shown here:
P00>>> set com1_baud 19200
Embedded Remote Console only supports 9600 baud. Continue?
(Y/[N]) n
bad value - com1_baud not modified
P00>>>
The syntax is:
set com*_baud baud_value
baud_value The new baud rate. A list of possible values is displayed by attempting
to set this environment variable to an unacceptable value (for example,
set com2_baud xxx).
Comentarios a estos manuales