Compaq dx2818 - Microtower PC Especificaciones descargar pdf (Pagina 123)

9. Connect external cables to the installed card, if needed. Connect internal cables to the system

board, if needed.

10. Replace the computer access panel.

11. Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide for

instructions on using Computer Setup.

Plastic Wire/Cable Fastener and Clips

Three different plastic wire fasteners secure many of the system wires. You have to loosen these

fasteners to gain access to the wires for several computer components. See the following illustration for

proper routing of wires.

To loosen the fasteners:

1. Prepare the computer for disassembly (

Preparation for Disassembly on page 83).

2. Remove the access panel (

Access Panel on page 84).

3. Rotate the drive cage to its upright position.

4. To open the round fastener (1), twist the two ends of the fastener until the ends come apart.

5. To open the square fastener (2), at the notch where the fastener latch connects, pull the top of the

fastener up and outward.

6. To open the fastener mounted under the hard drive (3), pull the latch on the right side of the fastener

directly downward.

To close the fasteners, reverse the loosening procedure.

Plastic Wire/Cable Fastener and Clips 113

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 161 162

Sin comentarios

Compaq dx2818 - Microtower PC Especificaciones Pagina 123