Compaq dx2818 - Microtower PC Especificaciones Pagina 149

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 162
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 148
If you have installed an operating system other than the factory-installed operating system, check
to be sure that it is supported on the system.
If the system has multiple video sources (embedded, PCI, or PCI-Express adapters) installed and
a single monitor, the monitor must be plugged into the monitor connector on the source selected
as the primary VGA adapter. During boot, the other monitor connectors are disabled and if the
monitor is connected into these ports, the monitor will not function. You can select which source
will be the default VGA source in Computer Setup.
CAUTION: When the computer is plugged into an AC power source, there is always voltage applied
to the system board. You must disconnect the power cord from the power source before opening the
computer to prevent system board or component damage.
Solving General Problems
You may be able to easily resolve the minor problems described in this section. If a problem persists
and you are unable to resolve it yourself or if you feel uncomfortable about performing the operation,
contact your HP authorized reseller or service provider.
Computer will not turn on.
Cause
Solution
Cables to the external power source are
unplugged.
Ensure that cables connecting the computer to the
external power source are plugged in properly and
the wall outlet is active.
Voltage selector switch on rear of computer
chassis (some models) not switched to correct line
voltage (115V or 230V).
Select the proper AC voltage using the selector
switch.
A defective PCI card has been installed. Remove any expansion board that was just
installed.
Drive data or power supply cables may not be
properly connected.
Reseat drive data and power supply cables.
The unit temperature was exceeded. The fan may
be blocked.
1. Unit is in an exceedingly hot environment. Let
it cool down.
2. Ensure that computer air vents are not
blocked and the internal fan is running.
3. Contact an HP authorized reseller or service
provider.
Computer appears locked up and will not turn off when the power button is pressed.
Cause
Solution
Software control of the power switch is not
functional.
1. Press and hold the power button for at least
four seconds until the computer turns off.
2. Disconnect the power cord from the electrical
outlet.
Solving General Problems 139
Vista de pagina 148
1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 161 162

Comentarios a estos manuales

Sin comentarios